Ultra electronics MAGICARD Sprinter Uživatelský manuál stáhnout pdf

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106

MAGICARD PRINTER

INSTRUCTIONS FOR REPLACEMENT OF

PRINTHEAD AND PRINTHEAD ASSEMBLIES

WARNING

- The Magicard colour printer contains hazardous voltages.

CAUTION

- The following procedures involve contact with Electrostatic Sensitive

Devices. All Precautions for handling Electrostatic Sensitive Devices should be

followed at all times, including the use of a grounded wrist strap.

HOW TO USE THESE

INSTRUCTIONS

The following procedures are intended to be used for replacement of Magicard

Thermal Printheads and

Magicard Thermal Printhead Assemblies.

If replacing a Thermal Printhead Assembly

do NOT carry out those parts of this

document written in italics

. These procedures, for head angle adjustment, require some

previous Magicard product training or experience, and must not be undertaken by end

users. Therefore end users are supplied with replacement Printhead Assemblies, which

have already been adjusted for correct head angle.

1 2 3 4 5 6 7 8

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 I MAGICARD PRINTER INSTRUCTIONS FOR REPLACEMENT OF PRINTHEAD

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 II 1. (a) Removing the cover Magicard 300 and Sprinter mo

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 III 1. (b) Removing the cover Magicard Turbo models. (1)

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 IV 2. Removing old printhead/assembly (1) Remove the dye-film a

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 V 3. Fitting the new printhead to the heatsink assembly (Magica

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 VI (3) Check that the springs at the back of the printhead asse

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 VII (4) The printhead angle has been factory set. In order to e

3461/07/01 ISSUE 2 PRINTHEAD INSTALLATION & COMMISSIONING SPEC. DCR No. 26106 VIII 7. And finally... If your new thermal printhead fails t

Žádné komentáře

Ultra electronics MAGICARD Sprinter Uživatelský manuál